Don’t tighten the screws too tightly at this point. Do the same for the left bracket with the other 2 screws and washers.
With the hex key, attach the right bracket to the right rear side of your license plate, using 2 of the 4 included cap screws and 2 of the 4 included stainless steel trim washers. Tighten each front screw, while ensuring that the horizontal brackets are perpendicular with the slot in the vertical section. Slide the horizontal section of each bracket so it is this distance from the top end of the vertical brackets. Using the included hex key, loosen the front stainless steel button-head cap screw on the left and right brackets. First, measure the distance from the lower edge of your bumper to where you want the top of your license plate to be. Installation is extremely easy, and takes about 10 minutes. Our low profile front license plate bracket comes pre-assembled in two parts – a left side and a right side, as illustrated in the sketches above. 2003-2022 step-by-step instructions are included with the bracket. THROUGHOUT OUR WEBSITE AND PRODUCT CATALOG THESE TERMS ARE USED FOR IDENTIFICATION PURPOSES ONLY. AMERICANMUSCLE HAS NO AFFILIATION WITH THE FORD MOTOR COMPANY, ROUSH ENTERPRISES, FIAT CHRYSLER AUTOMOBILES, SALEEN, OR GENERAL MOTORS LLC. CHEVROLET, CHEVROLET CAMARO, CAMARO, LS, LT, LT1, SS, Z/28, ZL1, ECOTEC, CORVETTE, ZO6, ZR1, STINGRAY, AND GRAND SPORT ARE REGISTERED TRADEMARKS OF GENERAL MOTORS LLC. 
ROUSH IS A REGISTERED TRADEMARK OF ROUSH ENTERPRISES, INC. SALEEN IS A REGISTERED TRADEMARK OF SALEEN INCORPORATED.
DODGE, DODGE CHALLENGER, DAYTONA 392, DAYTONA R/T, DODGE CHARGER, SRT 392, SRT8, R/T, RALLYE REDLINE, SCAT PACK, SRT HELLCAT, SRT DEMON, T/A, PENTASTAR, AND HEMI ARE REGISTERED TRADEMARKS OF FIAT CHRYSLER AUTOMOBILES (FCA). FORD, FORD MUSTANG, MUSTANG GT, SVT COBRA, MACH 1 MUSTANG, SHELBY GT 500, COBRA R, BULLITT MUSTANG, SN95, S197, V6 MUSTANG, FOX BODY MUSTANG,MACH-E, AND 5.0 MUSTANG ARE REGISTERED TRADEMARKS OF FORD MOTOR COMPANY.
0 kommentar(er)
